KING SPRINGS FORD RANGER PX-3
Heavy Duty Raised KING Coil Springs +55mm Lift PX-3 suited to 100kg - 250kg of constant weight or accessories.
This new part number suits the new PX3 Series Ford Ranger Manufactured after August 2018 on, PX-III.
STD Original Front Hub to Guard measurement to 550mm, This This is measured from the center of the wheel Hub up to the wheel arch.
RAISED Front Hub to Guard after installing the Kings KFFR-24 coil will be 585mm therefor leveling out your vehicle.
King Springs also manufacture a Heavy Duty option for a Bull Bar & a Winch. KFFR-24H
Due to the limited amount of Suspension Droop from this new ride height it is not recommended to use the KFFR-24H part number unless additional front end weight is fitted.
If additional Height Increase is required a 10mm Strut Spacer can be added.
At this stage No Aftermarket Front Struts are available for the New PX Series 3 Ranger. 2/10/18
This new generation steel allows King Springs to further improve many of their existing designs by reducing the amount of steel required in a spring, making it substantially lighter (by approximately 30%) and reducing the solid height therefore increasing travel.
Although considerably expensive, King Springs have introduced this new high stress steel to their passenger car and 4wd designs which benefit the most at no extra cost to the consumer. As of now all King Springs manufactured coils are now in X5K material.
Height Options
Many of our springs are designed to cross reference and give various height options on some vehicles. This information is too diversified and complicated to be printed and is often conditional. Please consult our technical staff if specialist height options are requested.
VEHICLE RIDE HEIGHTS (centre hub to guard)
An extensive library of vehicle ride heights is being compiled and this information is available to all customers.
Car Coils
Please note: The following height classifications are a generalization only. The degree of lowering or raising can vary between part numbers and vehicles. Spring design i.e. spring rate and vehicle height with shock travel. If exacting measurements are required for vehicle ride heights please contact us at WHOLESALE SUSPENSION ARNDELL PARK NSW 2148.
In general the first stage spring will raise or lower a vehicle approximately 30mm from factory standard.
Please note vehicles over 12 months old have normally settled and as the years pass sag considerably and may no longer sit at “factory height” giving the illusion of raising the car higher than stated or not lowering enough.
Measure the cars HTG height for a more accurate approach to ordering the spring in the height you require or for load carrying and to compensate for accessories please contact us at WHOLESALE SUSPENSION ARNDELL PARK NSW 2148.
NOTE: Super Low & Ultra Low coils generally drop in 10mm increments.
Over 25 Years Experience in the Suspension Industry:
Whether you require, Lowering Springs, Shock absorbers, Bushes, Coilovers, Strut braces, Lift Kits or steering components, Wholesale Suspension is your one stop Suspension shop, housing an enormous range of specialist suspension items for your car, four wheel drive, truck or trailer. Wholesale Suspension’s years of experience ensures that you will get the right advice and right parts at the very best price.
